Atomex 1:1 Ratio Low Pressure Plural Diaphragm Pump Bare

The Atomex LPMIX system has a bi-component low pressure double diaphragm pump with two flexible suction hoses. One side of the pump will draw part A and the other side of the pump will draw part B directly from a 20 or 15 litre drum. Each side of the pump will equally draw the material and pump to the external mixing chamber where part A will meet part B, at the end of the mixing chamber you would connect your 3/8" paint hose where both products are already mixed as they travel through the hose to the gun. 

At the back of the trolley is mounted a second pump which comes with a 20 litre suction hose set, this pump is designed to flush thinners through the mixing chamber when spraying has been completed. 

1:1 ratio pump systems are really good for spraying products like polyester or any paint material that requires a 1:1 mix ratio because the paint material is mixed after it leaves the pump.Flushingis not required until spraying stops which means if you had a few hours of spraying you would not need to flush the system until it has been completed. 

This system is only a bare package, you will require at least 5m twin air/fluid hose and either a pressure feed or suction feed spray gun. 

When using 1:1 plural mixing pumps you must check the manufacturers data sheet for the material being sprayed so that you understand the pot life of the mixed product.   

Atomex 1:1 Ratio Low Pressure Plural Diaphragm Pump Features - 

• Max fluid pressure 116psi
• Tungsten carbide valves
• PTFE wetted parts with stainless balls
• No lubrication required in pumps
• Solvent resistant suction hoses

 Atomex Part No. 15-480-005